Steps To Installing A Sump Pump

A sump is a pit in which water collects, whether in the home basement, mine or cave. It could be rain or spring water, drain fed or whatever, but it needs to be removed with a pump to prevent damage. Accumulated water in the basement would mean trouble through seepage and dampness spreading.  A sensor activates the pump when a particular water level is reached. In a DIY world exposed to massive updated information online, specific, relatively simple tasks around the home may be confidently taken up by amateurs. Get organized and arrange for a helper, maybe a kid in the family.

What tools and materials would you need to install a sump pump?

Make sure that all the tools and materials are available beforehand. Black marker, hole saw, and demolition hammer are important. Pipe cutter and shovel along with a bucket, would facilitate the process. Required materials would include the sump pump and sump basin. Further, you need pipe fittings and silicone sealant, J hooks, PVC pipe, trowel, gravel, and concrete.  The list may not be exhaustive.

Identify the spot and mark the hole boundary

Plan the top rated sump pump where water accumulates but ensure that safety norms are met with a GFCI outlet. Water and electricity can give rise to dangers, and the GFCI outlet protects. The sump basin will help in the marking of the circumference. It helps to mark the depth of the hole, whether on soil or concrete.

Dig the hole and wrap the sump basin

The demolition hammer will quickly open up the aperture to insert the sump basin that will not be very big. The gap should fully cover the sump basin. Protect the sump basin from muddy water by covering with filter fabric. Otherwise, the sump is going to get blocked.

Place the sump basin and pour gravel

Assuming that the fabric is wrapped on all sides, insert the sump basin in the hole. Now you need to pour three inches of gravel into the sump basin. Not only does the gravel form a base, but serves as the water collection and filtration system too.

Install the sump pump and connect the check valve and PVC pipe

Now it is time to place the sump pump into the basin above the pave. Connect the check valve and the PVC pipe to the pump.

Drill an outlet hole across the wall for the PVC pipe

According to the thickness of the PVC pipe, drill a trench across the nearby wall. The PVC pipe must extend a few inches beyond the wall. Silicone around the pipe will keep out insects and the cold wind.

Finishing touches

Cover the sump basin. Concrete the top of the sump basin for a neat look and let it dry. It is time to connect and test the sump pump by pouring water in the pool and operating the pump.

Where will the water go after flowing out of the PVC pipe? Perhaps it is the lawn or the garden bed that will receive the stream. Make sure that the water does not flow back to the basement.